SB-F-FLX-10W3v3 INSTR_SKU# 011293
InstallatIon
d I F F I C u lt Y :
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
out
oF
I n s t a l l a t I o n G u I d e
for the
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
35
SB-F-FLX/10W3v3
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
estImated tIme:
2-3 HouRs
sKu#94451
2009+
s t e P
1
Start off by cleaning out the back of the vehicle, it’s always
better to work in a clean environment.
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper
installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
s t e P
2
Remove the passengers side rear door sill.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
s t e P
3
Remove the false floor and, the tailgate door sill.
Continued on Next Page
SB-F-FLX-10W3v3 INSTR_SKU# 011293
I n C l u d e d H a R d W a R e
s t e P 1 2
Using a Unibit® or, a 9/16” drill bit, drill out the two holes
as marked in the previous step. do not dRIll deePeR
tHan 1/2” or you run the risk of scarring (or penetrating)
the outer sheetmetal of the car.
2) 3/8-16 x 2 1/4” Allen Head Set Screw
2) 3/8 x 2” Fender Washer
2) 3/8-16 Hex Nut
2) 3/8-16 Speed Clip
2) 3/8” Split Lock Washer
s P e C I F I C a t I o n s
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 10W3v3-4
Nominal Impedance: 4Ohms
Continuous Power Handling: 500Watts
s t e P 1 3
Slide the two Speed Nuts into location with the “Nut” side
towards the outside of the vehicle into position over the two
holes that were just drilled as shown. Install the two 3/8-16
x 2 1/4” Allen Head Set Screw with the Allen Head opening
towards the center of the vehicle.
P o W e R R e C o m m e n d a t I o n
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1v2
when being used to power your Stealthbox®.
s t e P 1 4
Hook up the wire from the amplifier to the Stealthobx®and,
slide the enclosure into place over the two Allen Head Set
Screws installed in steP 13. Mount the enclosure using the
included Fender Washers, Split lock Washers and, Hex Nuts
as shown. If neccessary, use a Allen Wrench to keep the Allen
Head Set Screws from rotating while tightening. Remember
to re-install the stuffing that was removed earlier and, rein-
stall the woofer. Test the system for proper operation. Put all
the stuff back in the vehicle that you took out in steP 1.
The JL Audio 250/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
m I d / H I G H F R e q u e n C Y d R I v e R F I t m e n t
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5”x 7” / 6”x 8”- Front Doors
Fits JL Audio Models: TR570-CXi, C5-570, C5-570x & ZR570-CSi
Rear Speaker Size / Location: 5”x 7” / 6”x 8”- Rear Door
Fits JL Audio Models: TR570-CXi, C5-570x
s t e P 1 5
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
(954) 443-1100
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011293 05-05-2009
•
Printed in USA
•
©2008 JL Audio, Inc. U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
•
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
•
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
•
3
3
0
2
5
•
U
S
A
Page 3 • JL Audio, Inc 2009
|